An aerofoil is a body shaped to produce an aerodynamic reaction (lift) perpendicular to its direction of motion, for a small resistance (drag) force in that plane. It achieves this by accelerating the flow passing over it, and decelerating the flow passing under it. This change in velocity causes a change in pressure, which in turn generates lift.

1st segment starts at screen height and finishes at gear retracted.

2nd segment starts when the gear is retracted and finishes when acceleration alt is reached (min. 400ft max 1000ft) speed V2.

3rd segment starts at acceleration alt, minimum 400ft, and finishes when the flaps are retracted.

4th segment starts when the flaps are retracted, MCT is set and finishes at the 1500ft.

Yes, VMCG has to be equal to or less than V1 to ensure the aircraft could maintain runway heading having suffered an engine failure at or above V1 when the aircraft is committed to takeoff.

You can go through a DA, but not a MDA.

A Decision Height, used in precision approaches, defines the point where a go around should be performed. It accounts for the altitude loss during the initial seconds of the go around maneuver.

The MDA does not account for this and assumes the pilot will never go below this altitude. When performing a CDFA most operators establish a Derived Decision altitude (DDA) to account for the extra lost altitude.

Mach tuck is a nose-down pitching moment experienced as an aircraft passes Mcrit.

Mach tuck is a form of longitudinal instability that is caused by the centre of pressures rearward movement (caused by the shock wave) behind the centre of gravity.

Mcrit is the aircraft’s Mach speed at which the airflow over a wing becomes sonic.

In a high bypass design, the vast majority of the thrust is derived from the ducted fan, rather than from combustion gases expanding in a nozzle.

A high bypass ratio provides a lower thrust specific fuel consumption (grams/sec fuel per unit of thrust in kN using SI units), especially at zero velocity (at takeoff) and at the cruise speed of most commercial jet aircraft.

High lift devices increase the lift produced by a wing, allowing the aircraft to operate at lower speed ranges usually for take off and landing.

Anhedral:

compensates for the wing sweep improves roll maneuverability

No. Carburetor heat uses exhaust air to heat air going into the carburetor. No electrics are involved.